IVA compliant bits

Had to add the final touches to conform to the IVA rules.

Headrest extensions for fixed seats. 50mm from top of seatI blanked off the side vents and siliconed round the lip as this could possible be below the radius requirements. The N/S has 2 holes with rubber edging.

Label for brake reservoir
Blunted/rounded door handles,
Switches have to labeled, but cos they are within the 127mm radius outside the steering wheel they are not radiused but also exempt. :P
Also had to cover the clock adjuster knob as it may be classed as sharp. (bottom middle dial)
EDIT: The Lights should read "Side & Dip"!

Mirror stub is contactable
Although the rear Fog supplied by GD that matches the reverse light is E marked, it wont pass as it has to be a parabolic lens designed fog lamp.
Front nose will allow the test sphere to enter and fail even with the number plate bar, so I made up a blank plate from MDF and filed the edges round and attached with some P Clips.
I fitted a steering wheel that has radiused edges and no slots like the motolita. Also used the Vecrta stalks as they show the correct symbols. EDIT: The centre of the steering wheel had to be padded for the retest, the inspector felt that it was a hard contactable area!? So i padded it with foam and gaffer tape. Think there will be a pic somewhere.

Boot handle too has some minor edges that could fail the test.

Best Speak to GD about these bits.